Sterilize-cash pure space tool - larva in Germany

The pharmaceutical industry makes nowadays very high demands against materials in sterile production areas to the employment comes. It plays thereby no role whether it product-affecting construction units or operational funds e.g. tool concerns. The used construction units as well as the assigned tools are prepared by routine by means of sterilization for the next employment, i.e. they go through a superheated steam autoclave or a hot-air sterilization tunnel/cabinet. The processes running off there represent an enormously high load for the used materials. The range of the site conditions with Sterilistationsvorgaengen is enough from 120°C and 100% rel. Air humidity (period: 15 - 20 minutes) up to 180°C dry heat (period: 30 minutes). The few at present on the market tool tools present get over these procedures durably without traces from corrosion to to point.Superheated steam finds its way also by finest hair-cracks, how they can occur e.g. with chromium-plated surfaces after use. Such "rust features" place each pure space technician or micro biologist before the decision with the existing quality (against better knowledge) to continue to work or the parts concerned by new acquisitions to replace, in the certainty that it concerns a recurring procedure here. With the support evenly those pharmaceutical enterprises attempts were accomplished for the production of noncorrosive tools from various materials and their behavior/AFTER autopiano processes. Constructing on analyses of surface effects by the material test institute Stuttgart was made possible for supplementing surface treatment procedures the production of almost all tools with most modern manufacturing and.Characteristic for the tools among other things their very good cleaning bar is, with approximately 50 RHC the hardness of conventional tools and the fulfilment of the requirements according to the valid standards of the tool production. A further not less important point is the stability opposite disinfectants in any form, caustic solutions, H2O2 and most acids. The program is rounded off by werkzeugkoffer, which are inferior in their execution of the quality of the tool in nothing. Thereby the sterilization process is simplified, since the tools do not have to be taken out of the suit-case or be packed individually into the autoclave. The equipment of the werkzeugkoffer can be adapted individually to the werkzeugbestueckung. For now 2 years supplies CCI - from Kahlden GmbH this Werkzeug Made to Germany to a multiplicity of considerable European companies.Due to the special materials, the complex phases of operation and the additional surface treatment steps our tools are clearly more expensive in the acquisition than conventional tools, however a Return on Invest justifies this price level within one period of 12 - 18 months.