The new multi-gas measuring instrument Microtector II G460

The small Jack of all trades measures each task up to 7 gases at the same time requires suitable solutions. This is valid particularly within ranges, within which potential gas dangers can occur. The new multi-gas measuring instrument Microtector II G460 of the GfG offers an optimal round around protection. Apart from the proven function and safety aspects with the measurement combustible gases and steams, oxygen as well as toxic gases, the G460 the world-wide smallest is simultaneous gas measuring instrument, with a 4-Strahl-Infrarot-Sensor for the CO2 and CH4 (NDIR) and a photo ionization detector (PID) to be equipped can and three further card locations had. This technical innovation makes it possible to measure and the large display show let at the same time the user SEVEN gases. The equipment is small, easy and handy and the ergonomic form provides for optimal stretcher comfort. By its impact, dust, and waterproof housing (IP67) the G460 is also in rauen environments as e.g. sewers without restriction applicable. With gas alarm takes place additionally to the loud acoustic alarm from 103 railways (A) an optical alarm on the display, like a traffic light coloured changes (gr�n=ok, gelb=Voralarm, rot=Hauptalarm). The announcement in the display can be turned and increased around 180� (zoom function). Reading off when carrying from the body is thereby at any time possible and the users has always both hands freely! For release measurements of tanks, pits or unbel�fteten areas a mountable high-delivery pump is available. The strong pump sucks in the measuring gas by a hose out up to 90 meters. The internal memory of the Microtector II G460 draws gas concentrations and alarms in the freely selectable interval during a long period on (e.g. interval of 1 Minute=30 hours of recording). The data can be transmitted immediately after the employment to a PC and evaluated there. For the future the user is prepared also with the innovative Dockingstation DS400, those for the fully automatic function test, adjustment and documentation of the G460 is used (in accordance with T021 and T023). Adjusting intervals are extended clearly and to reduce the temporal and financial expenditure for service work.� A function test takes 30 seconds, an adjustment is final after 3 minutes. In less than 5 minutes the equipment is again operational. The Dockingstation DS400 can be attached directly to a PC or the data on an internal SD-memory card placing. This makes the data seizure possible during one period of up to 30 years.

This text was translated automatically.